Recent content by Gralay

Hi l think we would all agree the heater is scrap and as ProfJohn has already said it could of been flooded so I would check units, floor and bottom of the walls for any delamination / discolouration. However looking at the photos it would seem that the combustion chamber of the heater is full...

Yes the SW carriers are a nightmare we keep our spare under the bed, however when we didn't have a fixed bed we travelled with the spare in the tow vehicle and as otherclive did put it under caravan when on site, this also ment Mrs gralay could cram more clothes in the wardrobe Gra

Looks like an ifor williams box trailer

Hi You could use a 12mm hex key if you can get enough purchase on it to slacken the receiver however when you refit the wheel the receiver will need to be tightened to the required torque, also I remember from an earlier thread that before 2013 the hex size was 10/11mm then 2013 onwards the...

I am another one in favour of Tyrepal, you know what your tyres are doing without seeing them.,if you are a member of the caravan and motorhome club you can get 20% off Tyrepal through member offers. Gra

Earlier this year when parking caravan using motor mover I could hear a quite loud click from one wheel and would momentarily stop then move again , so when parked I jacked up caravan and spun the wheel, no clicks and spun fine lowered caravan and click and momentarily stopping was back, so...

Hi When connected to EHU the charger should charge the battery if both are OK, no need to disconnect the battery when on site with EHU, the thing to be wary of is when not connected to mains as the battery will discharge slowly and could reduce the life of the battery. Hope this helps Gra

Hi welcome to the forum,hope you enjoy both caravaning and the forum.,have you got any trips planned.

Hi Don't know how how old ours is as I bought it off a forum member when they stopped caravaning. Gra

Hi welcome to the forum I have the same wheel lock the adapter sometimes needs a push to engage properly, the size of the hex drive is 12mm so if you have a 12mm hex key /Alan key you could try inserting that so you would then know if the adapter is at fault or the receiver. Gra

Hi Welcome to the forum We had the same problem with a 1996 swift corniche, the carver cascade 2 has 2 thermostats 1 to turn off the element when the water reaches 70 degrees C, the other is an overheat stat in case the other one fails to operate, the temperature of the overheat stat is 85...

Before digging around for the battery fuse check battery voltage and charge if necessary or put a known good battery on. Gra

Hi Stuart Welcome to the forum Looking at your first post it would appear that you have a problem with the 12v side of your electrical system, have you checked the battery voltage without ehu, it seems to me that either your battery as had it or the battery fuse may have gone. Hope this...

Hi Jim If the 12v lights are working OK the battery fuse is OK, so the problem is on the power supply, as you have checked the ps fuse and that is OK the only other things it could be are the plugs connecting the power supply to mains or the power supply itself. When checking the ps plugs...

If you have 12v to the pump you should hear it running its trying to pump water so could be a clogged filter on cold supply from pump to the first outlet /tap, could also be a faulty non return valve between the pump and first outlet/tap Gra