Recent content by Part-time Northumbrian

Thanks for the info. We're not really bothered about the original material just finding a good fit. We'll give them both a look.

Thanks will give them a look.

Thanks Beachball I have emailed Elddis and am awaiting a reply

Thanks Otherclive. I still can't find out how to delete my other 2 posts any help would be appreciated thanks.

Hi all, this weekend we went to empty and lock up our van for the end of season only to find some thieving so and so had been in and stolen our seat cushions and tried to rive our hob and sink out. Everything else was left intact and no damage done. Obviously the seating was targeted to order...

If anyone is following this post I have finally managed to dismantle the tap. After removing the handle the silver cap pulled off revealling a plastic fitting underneath which is held onto the cartridge by an ordinary screw. This fitting pulled off the cartridge lever but be careful as it has...

I had a problem where the cold water would run but not the hot. It turned out to be the non-return valve feeding into the heater tank had seized.

Hi Bluetonic, Thanks for the reply. I have unscrewed the handle but there appears to be no grub screw be it hex head or Torx which is mentioned in videos and other posts so I am at a loss as what to do. .

Hi I have what I believe is i Reich Trend E mixer tap which is leaking from one of the swivel joints. Research seems to indicate that changing the internal cartridge will solve this. The problem I have is getting the top cap off. There is no plastic grommet to remove to reveal any grub screws...

Damian thanks for getting in touch, I gather that the battery is required to be fitted at all times, I am just reporting that all things seem to work independently and together but the LED is still showing a fault.

Thanks for the advise everyone. I have checked things again. Things work as they should whilst running on 12v and the mains completely disconnected. When the battery is removed and the mains switched on everything works fine, the same as when the battery is also hooked up. Guess there's a...

Update to my problem and a request for more help. It appears that my battery was worn out and I have replaced it with a new one. After installing the Status indicator stayed Green for about 5 minutes and the reverted straight to Red again (No Amber). I have a voltage of 13.25 volts on the...

Thanks Bertie boy1, I will give it a go tomorrow.

Yes done that

Hi All. There are probably threads on here that relate to my query but I cant seem to find any so I'll save time and ask. Can anyone tell me how to check if my onboard 12v battery charger is working when plugged into the site mains? i have a 2007 Elddis Avante which just has the Red/Amber/Green...