Recent content by settloe_99

Agreed. I suppose I really need to know how it should be wired up correctly, and then I could start again and re-wire it correctly.

Thanks, Mr Plodd. I think the black cable is original, as I've traced it back as far as possible, and it seems to run into the wall or floor near the heating control panel. The blue wire has also been messed with at some point as when I traced it back, it runs to the negative terminal on the...

Hello, I've developed an issue with my Trumatic c3402 blow heater. The boiler works fine for hot water, but the blow heater has stopped working (or works very intermittently). When I took the cupboard apart to get to the boiler, I found that someone had previously disconnected the black wire in...

Thanks for the reply ProfJohnL So I opened the tap and then went to the inlet and put a multimeter on the terminals as I assumed there would be a current at the inlet terminals that the pump plugs into, but there isn't. It's the type with the microswitches in each tap, and yes, neither the...

Thanks, otherclive. So I started looking at the 12v system because I removed the water inlet yesterday after one of the retaining clips for the pump had broken off. I wired it back up and tested it before fitting it back, and all was working fine, but when I fitted it back into the van, there...

Thanks, otherclive, for your quick response. After more digging this morning, I've found a blown 20 amp fuse under the bed near the battery housing. I've replaced this, and now everything is working on 12v.

Hello, We've owned a 2005 Ace Jubilee Stateman for the last two years but have always used it on an EHU, so we've never really paid much attention to the 12v system, but when we've tried to use it today, we can't get it to work. I've attached a picture of the fuse board we have. With the EHU...