Hello there,
I bought a campervan with the carver cascade already installed. I made a test run and while filling up it leaked (pretty hard) around where the rubber O ring should seal everything off. I decided to tighten the bolt a bit faster, thinking the tank wasn't pressured enough but then the pole the runs trough the tank snapped
I guess I have two questions, one being the source of the leakage. I have a shurflo trail king (picture as attachment), max pressure 45 psi. Is this too much for the carver? And so probably the source of the leakage?
Second question is if this something worthwile to repair. Somebody have seen this before? Know a nice trick?
I've read about gary from arc systems, however we live in portugal.
I bought a campervan with the carver cascade already installed. I made a test run and while filling up it leaked (pretty hard) around where the rubber O ring should seal everything off. I decided to tighten the bolt a bit faster, thinking the tank wasn't pressured enough but then the pole the runs trough the tank snapped
I guess I have two questions, one being the source of the leakage. I have a shurflo trail king (picture as attachment), max pressure 45 psi. Is this too much for the carver? And so probably the source of the leakage?
Second question is if this something worthwile to repair. Somebody have seen this before? Know a nice trick?
I've read about gary from arc systems, however we live in portugal.