Thetford C250 flushing problem

[cobbers]

Hi All. Have been having problems for the last few months with my electric flush only working intermittently. Finally it appeared to fail altogether. Replaced it with a new switch about a month ago and all seemed ok. Last weekend whilst in the Eden Valley it developed the same intermittent problem ie sometimes flush sometimes not. When we left site on Monday it wasn't working at all. Any suggestions gratefully accepted as it has got me foxed.

 

[SirRogerFFS]

Hello Cobbers. I maybe able to help here as I had the same problem. If yours is the same as mine with press switch on the top and led full light to the left then I would suggest remove the switch again and just spay a little WD 40 onto the contacts on the board take it on and off a couple of times to help clean the inside of the connector as well and hey presto that should now work.As I said if this switch is the same as mine, also be careful not to press it too hard when you flush because the board bends that houses the little reed switch and it wont make contact.
I hope this helps. Sir Roger.

 

[cobbers]

Thanks Sir Roger. I did try that to no avail. I will give another go when we are back in the van tomorrow.