Recent content by WB369hut246tubilCANE125

Hi everyone ...Anyone know where I can purchase a ' FLAME DETECT ELECTRODE ' this is within the combustion chamber of the boiler ( Basically this Controls gas flow ) Thanks !

Thankyou once again ProfJohnL...I have looked at the PDF which I would describe as info. to Instal a complete Truma Ultra. Also checked the start up again, the whirring, may also be accompanied very quite continuous clicking noise, until the gas lights. It then remains lit for about 5+ seconds...

Hi ProfJohnL ......Thankyou for your comprehensive reply.. It looks like a stip down job.Going away in 3 weeks so will use elect. only until I return. ..When I switch the Gas water heater on after the loud click I think I can here a fan running then the flame ignites . Could the fan be stopping...

Good Morning EH52ARH... I have tested the Water Heater with the mains 240 volt connected.D.C Volts at present 13.7.. tried it over & over again. I even turned the supply off to W.Heater to allow it to reset. The GAS does ignite, but only stays on for 5 to 10 seconds then trips Thanks ...Brian

Thankyou for the speedy reply. Was in the process of being serviced that the Water heater fault was found .. Thanks Brian

:( Hi ..Have the above water heater on my Bailey Pageant Monarch S7. Year 2009 .Works perfect on electric.70 deg..However when I try to heat water on GAS the gas lights for about 5 seconds then trips out . When I turn the gas switch to on the unit clicks , then I hear slight whirring noise...