Had a right chew on with trying to get hot water after 240 v connection became unavailable. From a carver 1 we installed the newish gas chamber after finding the old one rusted to useless on the carver 2. After installing the flame came on and burned for 5-7 seconds then red light. So after more chew on soldered another burber module on that we believed to work and it worked!!! One day of hot water. Day later red light back on with same 5-7 second wait until it turns off again and red light comes on..... Bit sick of it, but never will one give up!!
-
We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.
3 x Carver Cascade Water heater 2 And still not working!?!?
- Thread starter Sanjo Malcini
- Start date
Try contacting Gary of Arc Systems he’s very experienced in these equipment and contributes to the Forum.
Thanks for the replies! I have two carver cascade 2's (aluminium tank), not din, More modern 4 pin connector. And 1 that I believed to be an earlier model, with din, but pretty much same otherwise. Defo not any of them circa 1979 haha, that looks more like a bomb.. Cheers ProfjohnL.
The Mk1 might look like a bomb but even so, it was a very reliable Bomb!! 😂
As for mk2 problems, sounds to me like a damp problem, first then try removing the burner module, Gas Turned Off First, once removed open black box and inspect both sides of circuit board for signs of water getting in? If not then leave it indoor in a warm environment, perhaps overnight, before reinstalling and immediately testing again to see if it works now while still 100% dry?
As for mk2 problems, sounds to me like a damp problem, first then try removing the burner module, Gas Turned Off First, once removed open black box and inspect both sides of circuit board for signs of water getting in? If not then leave it indoor in a warm environment, perhaps overnight, before reinstalling and immediately testing again to see if it works now while still 100% dry?
