Awning Wheel Covers

[Steve_374375660]

Any ideas welcomed on best way to fit the wheel cover inside an awning - they all come with press studs, but does anyone really drill holes in the caravan wall to fit these? I've tried hooks with suckers (normally for kitchen tiles - they just fell off) and have resorted to Duck Tape - not tidy! Apologies if this is already somewhere in the Forum - tried searching but didnot turn up any results Thanks Steve

 

[Jo-AnneFairway5402010]

what van is it for?. i have a proper one made buy bailey for the bailey twin axels which fits in part of the wheel arch cover.

jo-anne

 

[hughdavies]

I find they all come loose. So have cut out a suitable size pice of thin plywood that fits between the tyre and the wheel arch, you may find you have to flex it to get it in so use thin ply.

 

[cooky1]

I drilled a small hole through each press stud, bought a packet of plastic hooks and a packet of small rubber suckers. Then the wheel cover can be fixed to the van without any damage. Totac cost about

 

[GillC1]

Steve,

We use velcro, just a little square holds it on ok

 

[alaintaylor]

Hi

I use stick-on velcro, but the tabs stuck on the caravan don't look too attractive when not in use, but that's only when travelling so no real problem - so far the velcro has worked fine. I tried all other suggestions from this forum last year without success.

Alan