Carver mover not working

[Ray_5112937]

Carver mover fitted to twin axle van has decided not work.There is a green light flashing on the internal unit (7 long followed by 1 short)some sort of code i guess. Any help gratefully recieved.

Ray

 

[Val & Frank]

Hi Ray,

Do you have the manual ? I know with Truma they have a few tipa on what is wrong when the remote bleeps different combinations. Now is it three short followed by three long. or three long followed by three short. If that's the signal call out the life boat. ---))))

Val & frank

 

[Ray_5112937]

Hi Ray,

Do you have the manual ? I know with Truma they have a few tipa on what is wrong when the remote bleeps different combinations. Now is it three short followed by three long. or three long followed by three short. If that's the signal call out the life boat. ---))))

Val & frank

Well done Frank, managed to borrow an operating and installation booklet from a mate. All reprogrammed and now working fine.

Ray

 

[Viking1]

Ray

Look round the black box in the caravan or run your fingers round the out side of the boxes. You shod find a hole with a button in it.

Push the button in for 5 sec then push the on button on the control boxes and press one of the other keys.

This rye sets the boxes to the control boxes.

This happen when the battery has been tuck off.

Mark

 

[Ray_5112937]

Ray

Look round the black box in the caravan or run your fingers round the out side of the boxes. You shod find a hole with a button in it.

Push the button in for 5 sec then push the on button on the control boxes and press one of the other keys.

This rye sets the boxes to the control boxes.

This happen when the battery has been tuck off.

Mark

Cheers Mark, all sorted.

Ray