I own a 2005 Autoquest 400RL and intend to change the lighting to LED. Can anyone advise how I can remove the ceiling light dome covers to gain access to the bulb underneath? I can't see any screws that need removing so does the chrome bevel need to be prised off or does the cover unscrew?
-
We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.
Removing Dome Ceiling Light Covers
- Thread starter pepys1633
- Start date
On our (former) Autoquest 100 the dome covers clipped into the bevel. The way to remove the cover is to slide a slim blade between the cover and bevel and gently lever the clips out.
The bevel is part of the main fitting which is screwed to the ceiling.
Replacing the fluorescent lamp with LED (which I did in ours) is simply a matter of cutting the wires to take the ballast & lamp socket out of the circuit and wiring in the LED with a block connector. Remember to cut the wire from the switch on the correct side of the switch
The dome cover simply clips back in after the job is done.
Graham
The bevel is part of the main fitting which is screwed to the ceiling.
Replacing the fluorescent lamp with LED (which I did in ours) is simply a matter of cutting the wires to take the ballast & lamp socket out of the circuit and wiring in the LED with a block connector. Remember to cut the wire from the switch on the correct side of the switch
The dome cover simply clips back in after the job is done.
Graham
TRENDING THREADS
-
-
-
Mandatory eye tests for drivers over 70 being proposed by HMG. Good or bad?- Started by Dustydog
- Replies: 201
-
-
-
-
