Many years ago before Bluetooth I wanted to have a set of wire free headphones principally to watch television after the better half had decided to go to bed. I trailed several different methods. At the time there were RF analogue sets and Infra Red systems.
The RF system was sold under the Ross name (I know not perhaps the best name to inspire confidence) and it suffered with patchy reception even only a few feet away, It was difficult to tune and it did tend to drift a bit. and often were quite noisy with background hiss.
The other system I ended up using most was IR and sold by Sony. These were surprisingly effective. Being IR the signal needed line of sight with the transmitter, but as that was just under the TV set that was fine. The sound quality was great, and the only problem was the headset was on the ear pads which had quite a strong clamping force which became uncomfortable over long periods.
I cannot claim to have tried all Bluetooth systems but I have used various models in a number of sound applications for sound reinforcement and PA, and sadly so far I have been disappointed with them. I may be hyper critical because of what I'm trying to do with them, but I do find the ones I have used suffer with three common symptoms. The first and something that is a direct result of the Bluetooth protocols is the latency of the system. This is the short but noticeable delay between the source and the reproduced sound. A delay of around 5ms starts to become audibly noticeable. The second issues is the audio frequency response has been poor particularly in the low frequency region, And lastly the systems are subject medium range drop outs, and its not always possible to have multiple receivers driven by one transmitter.
I have been very sceptical about BT for AudioVisiual systems. Assuming the normal usage range in a domestic environment will not cause drop out, and the human brain can easily start to compensate for inaccuracies in frequency response, the biggest issue would be syncing of sound to picture because of latency issues.
As a consequence I tend to use analogue wireless where timing is important.
I am aware that some more recent systems are claiming much reduced latency, but as yet I have not tried them. I would echo the previous comments about only considering products from main stream manufacturers, and if possible try before you buy.