Recent content by metz

Empty post (likely not intentional - probably an Internet Explorer issue!)

Hi Sam, Yes you should be able to fit a Truma ultraheat to your room heater, the problem you may find though is on some foriegn vans there is not enough room at the back of the installation box for the ultraheat's control box due to the position of the blown air ducting, so check first, I've had...

Hi Fordbes, I would say there is a fault wth either the Control board, the data cable between the control and fuse board or the the board it's self, if your dealer can't sort it either contact http://sargentshop.co.uk/ or http://www.swift-talk.co.uk/

Hi, Take a look here http://www.filtapac.co.uk/index.htm I,m pretty sure fila pac are producing these now.

Hi Parksy, Yes at 2 years old your fridge needs a service, the chances are that the burner tube has rusted up, closing the burner ports therefore not allowing the gas to pass through pretty common with thetford fridges, a Swift Approved mobile fitter should be able to carry out the work for you...

Six minutes ?? what's up mate did you stop for a ***, or are you not feeling well?

Hi, The fridge you refer to according to my drawing is mains only. the drawing shows no gas input or 12 volt element present.

Hi Sprocket, I have the meter on your wish list I also have a sonic meter made by the same company, which means you can do a damp check without making the pin holes, the downside to that is if you pass the meter over the metal plates set in the walls or screws staples ect, the readings go...

Hi Charlie, No fitting a mover will not affect your warrenty providing any holes in the floor are sealed to spec and all other terms of the warrenty are met.and the mover is fitted to the manufacturers fitting instructions are followed. George. (METSERVICE Swift Approved Engineer)

Hi Drew, We have a tool for this job, but unless you use it on a regular basis it's expensive, i assume you have the seal in place and stapled down, then run a thin blunt blade around the recess, spray in the recess with a silicone spray (Mr Sheen)will do, then push the insert into the rear...

Hi Jeff, On a 2001 Bailey there should be an isolation valve for the heater, can't tell you where it is but there should be one, if so then make sure it's on, if the fire still won't light, it could be several things, a blocked burner, clogged injectors even a damaged control valve, i would...

Hi Highlander, I was a coachpainter signwriter back in the day, i repainted a ceiling in an Fleetwood i owned about 15 years ago, the surface of the ceiling board is a vinyl covering, i gave it a clean with some suger soap, then a thin coat of satin emulsion as close to the origanal colour as i...

Hi Dereck, If the dealer is either an NCC Approved Workshop or a Swift Approved Dealer then there should be no problem.

Hi Terry, Your Swift dos'nt have a water filter, the Swift Group have'nt used them for several years.

I think you will find that Alko say you can check the brake shoe wear through the viewing port on the back plate, you cannot check the seals, springs, actuators, or the condition of the drum thrugh this port, those us ho have been on the Alko chassis course carry out the service to their...