My Alko ATC is giving problems and I need to disconnect it. Is there a knack in how you pull the electrical connection off the ATC box.
ATC problem
- Thread starter Chris_374459623
- Start date
- Sep 4, 2011
- 591
- 362
- 19,135
Caravan details will help. But most caravans you will find a fuse box under the front seat attached to the bulkhead, Fuse for ATC power supply will be from pin 9 on a 13 pin plug and is Auxillary power supply .Removing this fuse will stop the ATC working.
Underneath the caravan there is a connector into the ATC , thats the best way.
When you its giving 'problems' what do you mean? as incorrect brake shoes/cable/handbrake adjustment is the main cause , the ATC when it goes through it self check, if the push moves too far it signals a fault , which is not the ATC it's the brake adjustment. also if you tow like an idiot if it detects too much sideways motion it will also signal a fault and lockup
When you its giving 'problems' what do you mean? as incorrect brake shoes/cable/handbrake adjustment is the main cause , the ATC when it goes through it self check, if the push moves too far it signals a fault , which is not the ATC it's the brake adjustment. also if you tow like an idiot if it detects too much sideways motion it will also signal a fault and lockup
- Nov 16, 2015
- 12,371
- 4,530
- 40,935
I think Chris is asking "how to remove" the plug from the ATC unit. There must be Clips or tabs to pull or push to release.
Thanks for all your suggestions. I have the ATC 1 control box and dropped it today , took 10 minutes and was able to see the how the plug into the unit was held. There is a clip on the top to be released. The Alko ATC 2 is a better design as the plug goes into the side of the unit and is easily accessible.
Facebook
Twitter