• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Blow Air Heating

S

SirRogerFFS

Right you Guys here we go .

Early on in the year we were away with our Compass Corona 524 only to find the Blow air didnt work, our mobile service bods found at the rear of the heater was a printed circuit board that had blown .

September we went away again and the same board had blown again .

My heating is now getting expensive I am almost frightened to use

the blown air incase it goes again .

Another new board has now been fitted also a new motor , if it goes again has anybody had this experience besides me ?

Please help.

Regards Stewart
 
Stewart, some more info would be helpful, such as how old is the van, and what heating system is in place.
 
I think you must be talking about a small pcb that fits on the Truma 'TEB2' fan housing and to which the control switch plugs into, it should have a little red rubber cover in one corner?

This pcb controls the fan speed and will be damaged by a worn or faulty fan motor, I suspect then in your case this is why the new one blew as well?

So now the motors also been replaced it's highly unlikely it will fail again.

I would say though, he was correct to try just replacing the pcb the first time, I've repaired many of these boards without replacing the motor and have not to date had one fail a second time!
 
I think you must be talking about a small pcb that fits on the Truma 'TEB2' fan housing and to which the control switch plugs into, it should have a little red rubber cover in one corner?

This pcb controls the fan speed and will be damaged by a worn or faulty fan motor, I suspect then in your case this is why the new one blew as well?

So now the motors also been replaced it's highly unlikely it will fail again.

I would say though, he was correct to try just replacing the pcb the first time, I've repaired many of these boards without replacing the motor and have not to date had one fail a second time!
Click to expand...
Gary ... many thanks for that I feel alot easier now .

I do have faith in the the guys that have done the work but I felt another opinion was needed here.

Kindest Regards Stewart. ps Have a great Christmas and New Year
 
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Back
Top