Hello
Does anyone know if a cascade MK2 controller can be used on a MK1 cascade?
I have refurbished my MK1 but it will not run. I have a 10.8 volt supply and water and gas connected. I have checked the continuity of the 6 core cable and all is ok. The original heater had a controller with a rocker on/off switch 3 led lights and a rotary knob. The heater I have bought and refurbished has a controller which has a sliding on/off switch 1 led and a rotary knob. Neither controller lights up nor the heater will not light. Also I cannot hear the solenoid or the spark generator.
As MK1 controllers seem scarce, are it possible to use one from a MK2, is there any difference between them?
Any advice would be welcome.
Read more at http://www.practicalcaravan.com/forum/new-members-say-hello/49473-carver-cascade-mk1-controller#6A9Fzc3lSUJsym5r.99
Does anyone know if a cascade MK2 controller can be used on a MK1 cascade?
I have refurbished my MK1 but it will not run. I have a 10.8 volt supply and water and gas connected. I have checked the continuity of the 6 core cable and all is ok. The original heater had a controller with a rocker on/off switch 3 led lights and a rotary knob. The heater I have bought and refurbished has a controller which has a sliding on/off switch 1 led and a rotary knob. Neither controller lights up nor the heater will not light. Also I cannot hear the solenoid or the spark generator.
As MK1 controllers seem scarce, are it possible to use one from a MK2, is there any difference between them?
Any advice would be welcome.
Read more at http://www.practicalcaravan.com/forum/new-members-say-hello/49473-carver-cascade-mk1-controller#6A9Fzc3lSUJsym5r.99