Hi,
I've been trying to get to the bottom of why our Thetford C250 series toilet has stopped flushing water into the pan. Following videos on YouTube I located the little circuit board with the push switch under the sticker on top of the toilet and removed the push-on 8 way connector plug to see if the contacts were tarnished.
Unfortunately the red wire has now broken off just where it goes into the connector plug, so I can't go any further until I get it reconnected.
Can anyone advise the process for removing the end of the broken wire from the connector plug and re-inserting the wire that has come out again?
I 've attached a stock photo of the connector I mean - its the red wire that become detached on mine.
Regards
Dave
I've been trying to get to the bottom of why our Thetford C250 series toilet has stopped flushing water into the pan. Following videos on YouTube I located the little circuit board with the push switch under the sticker on top of the toilet and removed the push-on 8 way connector plug to see if the contacts were tarnished.
Unfortunately the red wire has now broken off just where it goes into the connector plug, so I can't go any further until I get it reconnected.
Can anyone advise the process for removing the end of the broken wire from the connector plug and re-inserting the wire that has come out again?
I 've attached a stock photo of the connector I mean - its the red wire that become detached on mine.
Regards
Dave