reich tap microswitch

[Andrew_5080451]

Hi I am trying to fit a new switch to my tap i have it all stripped as per handbook, but i was wondering how u get the wires out from down the side of the tap and reconnect the new ones on it.

Thanks in advance

Andrew

 

[Drmartin_5091967]

Hi Andrew, The tap must be completly dismantled to fit a new microswitch. When you reassemble the new wires fit down the one side between the cartridge and the body of the tap. When you have it apart you will see a recess for the wires. hope this helps.

 

[Andrew_5080451]

HI thank you for your answer but i have it totally stripped down to the switch and i can see the wires disappearing down the side of the tap, i was wondering do i just pull them out and push new wires down or is there a more sceintific way of doing it lol.

Thanks

Andrew

 

[Drmartin_5091967]

Hi, I dont think you will be able to feed the wires down the side of the tap internals. I had to remove the tap internal ceramic cartridge, feed in the new wires and replace the ceramic incert and locking collar. It is a complete tap stripdown.

Regards Dr martin

 

[Andrew_5080451]

so am i right in thinking the wires just pull out and new wires slide into place and secure themselves.

Thanks

Andrew