There is a thin rigid plastic part that lies immediately above the flush handle on my loo (white plastic maybe 1.5mm thick) that has become brittle with age and now lost some bits leaving an uneven sharp edge. Probably this is out of the way of fingers but perhaps someone can help. Is it possible to swivel the bowl section so that it can be lifted off (bayonet style?) so that I can replace the part? I've had a good look at the 'exploded' parts diagrams on the Thetford website but cannot see this as a replacement anyway, so the job might need a bit of 'Heath Robinson' effect to repair!
Thetford C260 series
- Thread starter audiorob
- Start date
I tried in the passed and discovered the bowl was not replaceable. A whole new unit is needed. The diagram below covers the 260 too. Hope it helps.
Thanks both for your prompt replies- think I’ll take some photos of the base of the loo from inside the locker and see if the principle is the same then consider the task in the light of the video alongside the diagram
Facebook
Twitter