Recent content by Drmartin_5091967

Robert, How has the araldite held up on your window. I have just bought some 2026 to do mine. After all the internet research I've done It is not the best glue to use but the proper stuff is unavailable to the general public.

Thanks guys very much. I will look into your various suggestions. And report back when I've fixed the window. Many Thanks

Has anybody had the inner and outer plastic window pieces come apart. I can now lift open the front large center window, leaving the inner still locked from the inside. Any ideas re a suitable glue/cement to reseal the two parts together. thanks

Hi, I dont think you will be able to feed the wires down the side of the tap internals. I had to remove the tap internal ceramic cartridge, feed in the new wires and replace the ceramic incert and locking collar. It is a complete tap stripdown. Regards Dr martin

Hi Andrew, The tap must be completly dismantled to fit a new microswitch. When you reassemble the new wires fit down the one side between the cartridge and the body of the tap. When you have it apart you will see a recess for the wires. hope this helps.

Hi, On my alarm i had to remove the main unit box with the enclosed rechargable battery and disconnect the battery,(I had to drill the pop rivits to get into the box). leave it for half an hour or so and then reconnect. Mine had then defaulted to the factory setting of 0000. Alarm " plug in...

Hi, On my alarm i had to remove the main unit box with the enclosed rechargable battery and disconnect the battery, leave it for half an hour or so and then reconnect. Mine had then defaulted to the factory setting of 0000. Alarm Idna plug in systems Manufacture fitted. What make is yours

Hi Everyone, I'm doing some repairs to my 1999 Elddis crusader and need to find the colour code for the outside paintwork. Does anyone know if it is marked anywhere on the van or is my only option to contact the very unhelpfull Elddis customer services.

Hi John. Received your photos. As you said my cooker has the same unfinished holes at the back of the oven.....very strange...but obviously as it should be. Perhaps I'm expecting to much from a caravan cooker. Thanks again for all the trouble you went to regarding taking the photos you are truly...

Thanks John much appreciated.

Hi Martin, I have the manual but it doesnt show the inside of the oven, it is also about as much good as a Tit on a billy goat. Can't find anything on google regarding my oven.But thanks for your input.

Come on guys isn't there anybody that can help me with this. there must be a few of you with the same oven installed in your caravan.Here's hopeing.

Hi All, I seem to have a problem with my Stoves Vanette 9000 Oven. We tried to cook a pizza a few weekends ago and found we had to have the oven on for ages...It just didn't seem to get up to temperature. When I had a look at the flame all looks okay...but I noticed that there are two 1" holes...

Hi Stuart, I'm about to do the same job. I too have looked into the tube and roll mastics and have spent many hours looking at which is the best solution and seal as i only want to do this job once. My conclusion is to use the roll mastics. This is what the manufactures use. I have just found...

Hi, Thanks for your comments guys,and thanks Gill C for the link. I'm being a bit fussy now but these are gray and I would realy realy like a green one. Anybody else know where to get one from.