2006 Bailey pageant water pump

[Darm32]

Hi I'm new here, I have a 2006 Bailey pageant, My water pump keeps stopping working, the light on the switch beside Master keeps going off I have Checked Fuse and loose connections
Any ideas be greatly appreciated
Thanks

 

[Woodentop]

Pageant is just a series of different models, so you have a Bailey Pageant what?

 

[Darm32]

Apologies its a Bailey pageant Bordeaux

 

[otherclive]

I had a Series 5 Bordeaux. Lovely caravan. It could be the adjustable pressure switch needs readjusting. If you have the Owners Manual the procedure is detailed. Very simple no special tools required.

This link will probably cover your caravan despite it being

Adjusting Pressure Switch; Onboard Water Supply (Senator) - Bailey 2002 Series Owner's Manual [Page 36]

Bailey 2002 Series Manual Online: adjusting pressure switch, Onboard Water Supply (Senator). If The Battery Voltage Is Not Constant, Cycling May Occur Even At Higher Flow Rates. This Can Be Minimised By Adjusting The Switch's Diaphragm Sensitivity As Follows: I. With The System...

www.manualslib.com

 

[Dustydog]

My Pageant Series 5 Vendee had the submersible pump in the aquaroll. Non adjustable. Over the three years I had two replacement pumps. In fact we carried a spare !
If yours is a submersible I suggest you try it in someone else’s or buy a new one . They don’t always blow a fuse when they fail. How old is your pump?

 

[Hutch]

If it is a submersible pump, normally the contacts at the caravan wall is the problem, a clean with a nail emery board, Steal it from your wife or partner, and try again. Over 15 years I have replaced one Truma pump and now use a whale pump on the Truma connector to my Coachman at least every trip I have to " Wiggle " the connector to make the electrical connection.
Always carry a spare pump and hose unit.

 

[MelissaPeters]

If yours is a submersible I suggest you try it in someone else’s or buy a new one . They don’t always blow a fuse when they fail. How old is your pump?

Speed Test​

 

[audiorob]

Recently replaced my whale pump - all working fine but the plastic neck on the pump that connects to the hose had become brittle and snapped right by the housing - I chose to buy the whole kit from a Whale supplier but could have bought a generic pump of similar capacity/flow rate and rebuilt the original.