Delam'd floor

[matthew_374303743]

my floor has dipped a bit as well as being spongy. Is there any way I can raise it back up before injecting the resin? I thought I could maybe jack the floor up from underneath but am slightly concerned about the floor breaking under the strain.

Thanks

 

[UKHunk]

Yea you can jack up from underneath useing planks to spred the load but only only up to the floor to support it,then from inside the van you will have to remove the carpet and drill 8mm holes about 4 to 6 inches apart,and then go from there if you think the floor needs to have a piece removed,then you can say remove a small portion at a time,the glue you use to repair the floor is quite flexible,i drilled over 90 holes in my floor and removed some of it,i have now done the job and fitted a new carpet and it is as good as new,Good luck to you with your repair,

 

[vauxhall2]

my version for what its worth

hi,delamination...frightening no if you set out your stall and take your time.this is not a two hour job as stated,when you have finished you will know why they charge so much at the caravan repair shop.i have just done ours a few months ago.i will go through the steps best i can.ours had gone in two places,next to the door entrance and next to the sink four feet away.you will find that delamination is where the floor is used most.ie next to the sink and the door entrance.first decide how much delamination you have,ie.2 feet (old school) or 6 feet,this information is required when you go to order your epoxi resin mix.one mix will cover about 3 feet by 3 feet.got mine from barrons

 

[kobudo]

my version for what its worth

hi,delamination...frightening no if you set out your stall and take your time.this is not a two hour job as stated,when you have finished you will know why they charge so much at the caravan repair shop.i have just done ours a few months ago.i will go through the steps best i can.ours had gone in two places,next to the door entrance and next to the sink four feet away.you will find that delamination is where the floor is used most.ie next to the sink and the door entrance.first decide how much delamination you have,ie.2 feet (old school) or 6 feet,this information is required when you go to order your epoxi resin mix.one mix will cover about 3 feet by 3 feet.got mine from barrons