• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Hub nut torque

That figure is correct. Also if you remove one, replace it with a new one. There are two sizes, 32mm and 36mm.
 
Thanks guys sorry mabout delay in replying but work took over. I did replace both one shot nuts with new ones although the old ones had 36mm nuts but the new ones had 32mm. Thread and overall outside diameter were the same . Thanks again Richard.
 
Because they are not round, they are slightly elliptical. They rely on this tightness not to come loose. Obviously once they are removed, they've lost the shape. Personally I think it's a rotten idea. A castellated nut with a split pin was much better.
 
The 32mm and 36mm hub nuts are meant for two different axles. There overall diameters are different as well. One is 50mm, the other 58mm. I'm sure Alko wouldn't go to the trouble of manufacturing two sizes if the one would do. I know it's a waste, but if I were you, I'd put the correct one on.
 
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Back
Top