Ok Ron, this is what the manual says :-
Pull the cover forward at the top, lift the rataining springs and fold out cover forwards. (If space is limited, lift the cover upwards and forwards, lift until the cover is released then remove it)
Set the cover in position on the sides, so that any connection cables which might be present(e.g for the piezzo isniter, the hot air fan, and the ignition monitor lamp) do not have to be unplugged.
For assembly, place the cover on the lower retaining lugs at the bottom. Guide the operating bar from below into the handle sleeve and allow the cladding to engage at the top.
** S 3002 (P) only. Press the operating handle into position from above in such a way that the arrow points to the "O" position. **
I hope that this is the information you need, if you are coming to the easter meet, I can show you the manual if you are interested.
Lolly x