My Lever which is the flat type with a pressed steel tube has become elongated and there is at least half a turn of movement before the mover starts to move onto the tyre. The lever hits the ground and the mover will not engage. Does anyone know of a conversion such as an adaptor in solid steel or something better. The lever is part no 60030-0046-00
-
We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.
Truma SR Mover actuator Lever
- Thread starter harryy
- Start date
Long time since we had that type of mover but the lever end was a standard wheel nut one. There are longer levers of this type available so I would be looking at these or alternatively a socket set with a long enough handle.
Our Powertouch one uses the same head so one of theirs might be an alternative as ours has not bent although I have not checked what it is made of.
Our Powertouch one uses the same head so one of theirs might be an alternative as ours has not bent although I have not checked what it is made of.
Harry
You could go to a decent engineering shop or welder and ask them to make you a stronger one. Or ask , tongue in cheek, for Truma to replace it foc on the basis it has an inherent latent defect and is not fit for purpose . I guess yours is outside all the consumer legislation but it's worth a punt.
You could go to a decent engineering shop or welder and ask them to make you a stronger one. Or ask , tongue in cheek, for Truma to replace it foc on the basis it has an inherent latent defect and is not fit for purpose . I guess yours is outside all the consumer legislation but it's worth a punt.
