It's a simple matter of adding a contactor between the EPS output of the inverter and part of the main CU input and adding a separate earth rod. Took 2-3 hours to do. Parts if not using solax bits are less than £120.Our Solax battery was supposed to power the house in the event of a blackout, we found out apparently not, we need another device added for it to power the house in the event of a blackout
I think it will be many years before we see heat pumps and EVs on the scale you envisage. I for one would replace the condensing boilers in our house and our daughter’s house as both are currently beyond 10 years old. Of course that may not be the right decision if the cost of electricity does drop dramatically and gas takes its place as the top price fuel.Its complicated.
We have large amounts of old housing stock that are not thermally efficient nor capable of realistically being upgraded. Various attempts by successive governments to do so have resulted in many disasters.
New builds still lack many considerations for thermal and energy efficiency, although building regulations have been enhanced but don't go far enough in my opinion. Problem still is that like the caravan industry the major developers lack good quality control and, admittedly the few new houses we've come across, have ticked the boxes but are still poor quality in respect of energy efficiency and good thermal properties.
Interesting article the other day about the Netherlands where they have many green energy sources and good take up of supposedly efficient heating systems and EV cars. They are running into gridlock situations.
While there are many Mwatts being generated and could be used, the final few km/miles of wires to communitues cannot support the local demand. This could well be a problem the UK faces if everyone is forced to install heat pumps and run EV cars. The demand will out strip the supply of Watts where you need it - at home for example.
All depends on what you did for a living before you retired.It may seem like a simple process but really should be carried out by a qualified engineer. Especially if you want your house to meet the relevant certifications.
Same hear multi skilled Qualified Engineer all my working life. Paid very little all my life for others to do any work for us.All depends on what you did for a living before you retired.
When we got this place I rewired the house and just paid someone to come in to test and certify the installation it as it was cheaper than certifying it myself with the council.
One of the joys of having worked with electricity all my life.
About 8.5 years payback here and we are almost half way there.But depending on where you live and how much at home time you have. Solar Panels may take from 11 to 15 years or more to recover the installation cost.

I've done the same but wouldn't suggest to anyone else who's skillset was unknown how to do the same.Same hear multi skilled Qualified Engineer all my working life. Paid very little all my life for others to do any work for us.
If you'd saved your outlay for 8.5 years at 4% per year, compounded, you'd have got about 36% and still have the initial amount.About 8.5 years payback here and we are almost half way there.
It was predicted to be 11 years just before the electricity prices went up but due to that and decent tariff management it's come down to about 8.5 years. I don't need the money back as I can't take it to the grave so will be content with between 11 and 12% ROI.
The "payback" period can only come down as prices rise.
I would say that my solar installations* have added their value to the overall house value so I haven't "lost" the money at all.
* Solar PV and Solar Thermal for hot water.
View attachment 9809
Hi Gumpy excuse my grammar I have a brain injury, we have a 4.4kWh solar panels with a Solis AC inverter, Solax Triple 5.8kWh battery and Solax AC inverter, the contractor who fitted the system was HIES registered, how ever they were not MCS registered to fit the battery, too be honest they made a bit of a mess.It's a simple matter of adding a contactor between the EPS output of the inverter and part of the main CU input and adding a separate earth rod. Took 2-3 hours to do. Parts if not using solax bits are less than £120.
Solax make two EPS boxes
One manual
One Auto![]()
SolaX X1 EPS Emergency Power Supply Box UK - Manual Switch - Solar Trade Sales
www.solartradesales.co.uk
![]()
SolaX X1 EPS Emergency Power Supply Box EU - Automatic Switch - Solar Trade Sales
www.solartradesales.co.uk
Alternatively you can wire a 13amp plugboard through an RCBO from the EPS output and distribute it to wherever you need it.
I started with a 5.8kWh battery and over the last 3 years have added two more. I now have enough capacity to last 24-36 hours without using the grid which means we are effectively off grid and use no supplier electricity from the end of February to mid October.
Do you mean FIT, I thought that disappeared in 2019?Our battery was fitted in October 2022 under the old regulation , we live in a bungalow, and installed inside the hall cupboard
But once the war in Ukraine comes to an end and western countries dependence on fossil fuels for electricity reduces prices are likely to reduce again and payback period will extend. Plus if UK can find a way to divorce energy prices from the benchmark of fossil fuel wind and solar charges should reduce even further.About 8.5 years payback here and we are almost half way there.
It was predicted to be 11 years just before the electricity prices went up but due to that and decent tariff management it's come down to about 8.5 years. I don't need the money back as I can't take it to the grave so will be content with between 11 and 12% ROI.
The "payback" period can only come down as prices rise.
I would say that my solar installations* have added their value to the overall house value so I haven't "lost" the money at all.
* Solar PV and Solar Thermal for hot water.
View attachment 9809
